User manual

22
 NETWORK
1) Two Ethernet available: Ethernet 0 and 1.
2) Click ip address cell to get the on-screen keyboard. Change ip address if
needed. Click again to close the on-screen keyboard.
3) Select STATIC or DHCP.
4) Click [SAVE] to save and exit network setup.
 SETUP
1) Setup current data/time. Point the cursor on the date/time and use
the wheel on the mouse to change the date/time. Click [APPLY TIME]
to save the changes.
2) Select language. System must reboot to change to the set language.
3) SYNC IPCAM PARA：Can set whether to start synchronization,you can
configure this interval.
4) Can be set whether to open the map function.
5) Firmware update: Save updated firmware on a USB and insert it to the
USB slot on the front panel. Click [USB UPDATE]. (Note: the updated
firmware must save on top layer on the USB).
6) Config Initialize: Click [CONFIG INIT] to reset the system to factory
default setting.
7) System Reboot: Click [REBOOT] to reboot the system.