User manual

14
7) Point the cursor and click the IP address under new IP that needs to be
changed. On-screen keyboard will popup in the screen. Click again to
close on-screen keyboard.
8) Make sure all NEW IP addresses are correct. Mark the cameras that will
connect to the NVR. Click [SELECT ALL IPCAM] on top-left corner to
apply to all cameras. (Note: the maximum number of cameras supported
is 16 units). Click [APPLY] when ready to connect.
Caution! IP addresses of NVR and cameras cannot be the same. Default
IP address of NVR is 192.168.1.69.