Use and Care Guide

1. Verify that the power cord is disconnected from the power outlet. Ensure that the tank is clean

and free of dust and dirt. (Fig. 1)

2. Remove the cartridge lter and install the foam wet lter over the lter cage and place the

power head back on the collection tank. For lter installation instructions see page 13. (Fig. 2)

DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.

OPERATING INSTRUCTIONS: WET VACUUMING

3. Fit the desired nozzle to the vacuum hose. (Fig. 3)

4. Ensure that the switch is in the 'O' OFF position before plugging the power cord into the power

outlet. (Fig. 4)

5. Turn the motor on by ipping the switch to the 'I' ON position. (Fig. 5)

6. After use, ip the switch to the 'O' OFF position and unplug the power cord. Empty and dry the

collection tank. (Fig. 6)

IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely

in the liquid; leave a gap at the tip of the nozzle opening to allow air inow. The machine is tted

with a oat valve that stops the suction action when the collection tank reaches its maximum

capacity. You will notice an increase in motor speed. When this happens, turn off the machine,

disconnect from power supply, and drain the liquid into a suitable receptacle or drain. To continue

vacuuming, ret the collection tank with the drain cap. After wet vacuuming, turn the machine

off and remove plug from power supply. Empty the collection tank, clean and dry the inside and

outside before storage. REMEMBER! The foam lter must be removed after wet vacuuming and

a cartridge lter must be installed before dry vacuuming again.

BLOWER OPERATION

WARNING:

ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN

CANADA, CSAZ94.3) BEFORE USING BLOWER.

WARNING:

KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.

WARNING:

WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE

INHALED.

This Wet/Dry Vac has blowing capabilities. To use the blower feature follow the instructions listed.

1. Verify that the power cord is disconnected from the outlet. (Fig. 1)

2. Make sure the collection tank is empty before using as a blower.

3. Remove hose from the vacuum port. Remove noise diffuser from blower port.

4. Insert the larger end of the hose into the blower port on the back side of the power head. (Fig. 2)

5. Fit the desired attachment to the hose. (Fig. 3)