Operating Guide

9
BLOWER OPERATION
WARNING: ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN
CANADA, CSAZ94.3) BEFORE USING BLOWER.
WARNING: KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING: WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
INHALED.
This Wet/Dry Vac has blowing capabilities. To use the blower feature follow the instructions listed.
1. Verify that the power cord is disconnected from the outlet. (Fig. 1)
2. Make sure the collection tank is empty before using as a blower.
3. Remove hose from the vacuum port. Remove noise diffuser from blower port.
4. Insert the large end of the hose into the blower port on the back side of the power head and
screw into position. (Fig. 2)
5. Fit the desired extension wand and / or nozzle to the vacuum hose.
6. Verify that the switch is in the ‘O’ OFF position before plugging the power cord into the outlet.
7. Before turning on the vac, rmly hold loose end of the hose. Turn the motor on by ipping the
switch to the ‘I’ ON position. (Fig. 3)
8. The unit will now blow through the vacuum hose and can be used to clear obstructions within
the hose. (Fig. 4)
9. Once you have completed vacuuming, ip the power switch to the 'O' (OFF) position and unplug
the power cord from the outlet.
1
2
3
4