Operating Guide

11
WARNING: ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWER HEAD FROM THE COLLECTION TANK.
INSTALLING & CLEANING CARTRIDGE FILTER
2 3 4 5 61
Installing Cartridge Filter
1. Verify that the power cord is disconnected from the outlet. (Fig. 1)
2. Remove power head and place in upside down position.
3. Install the cartridge lter over the lter cage with the at end of the lter towards the power
head. Carefully push lter in until it stops against the power head. (Fig. 2 & 3)
4. Place lter retainer on top of cartridge lter over the raised lip and tighten down by turning
retainer clockwise, do not over-tighten. (Fig. 4 & 5)
Removing and Cleaning Cartridge Filter
1. Unlock and remove the lter retainer by turning retainer handle counter clockwise.
2. Carefully hold and pull the cartridge lter up for removal. (Fig. 6)
3. Clean the cartridge lter by gently tapping or brushing dirt off. Cleaning should not be done
indoors in living areas. For optimal performance a new lter is recommended.
4. Install cleaned or new lter as instructed above in steps 2 and 3 of Installing Cartridge Filter.
5. Wet lters should be removed and allowed to air dry for 24 hours before installing onto the lter
cage.
IMPORTANT!
Clean or change the cartridge lter regularly for best performance.
ALWAYS USE CARTRIDGE FILTER FOR DRY VACUUMING.
If the machine is used without the
cartridge lter, the motor will burn out and the warranty will be voided. Always keep spare lters on
hand.