User Manual
7
(3) Remote Control Instruction
Install Batteries
1) Open back cover of battery component on the back of remote control.
2) Install AAA type batteries, make sure battery positive and negative pole are correct (“+”to”+”, “-” to “-”), please do not mix using old and
new batteries.
3) After batteries are installed, close the back cover, and make sure the clip is buckled to the bottom.
Range of remote control
Remote control can normally operate within 8 meters, 30 degrees left and right from the remote-control receiver; in order to protect
environment, please dispose waste battery into recycling box.
If the battery is replaced by an incorrect type, it may lead to explosion.
Connection and Setting
For the safety of you and the machine, please do not connect any power plug before connection.
1. External Computer and Touch Connection
1) Use VGA cable to connect to VGA output port of external computer, and meanwhile use headphone audio cable to connect to external
computer audio output interface. (Or use HDMI cable to connect to HDMI output port of external computer).
2) Use USB cable to connect to external computer USB port.
3) After cable connection, plug in power cord, and switch power on.
4) Start external computer.
5) Press key, and the equipment is power on.
6) Switch the input source to the VGA/HDMI channel in the main menu.
NOTE:
External computer input, equipment’s highest resolution is 3840 x 2160 px.
Recommended computer conguration:
1GB Available Hard Drive
2.0GHz Processor, 1GB Memory
More than 256 color display cards
VGA OUT / HDMI OUT, Audio-OUT, USB Interface
Supported Resolutions: 800x600,1024x768,1920x1080,3840x2160