Operation Manual

5.8.1 Zoom in after find
When this switch is turned off, V7 Navigation will center the map to the location
selected in Find but will not change the zoom level. If you turn this switch on, V7
Navigation will also zoom in to the selected point.
The zoom level in this case depends on the type of object you have searched for.
For example in the case of a city search, the zoom level will show you the whole
settlement or at least a significant part of it around its center. Selecting a POI, a
junction or an exact address will give you a closer look with only a few streets on the
display.
5.8.2 Coordinate display format
Positions are sometimes displayed with their addresses, and sometimes with their
coordinates. This setting lets you choose between displaying coordinates in degrees
(dd.dddddd); degrees and minutes (dd mm.mmm); or degrees, minutes and seconds
(dd mm ss.s).
Note: the coordinate display mode is independent from the coordinate input in the
Find & Go menu. You can use all three formats freely on the coordinate input screen.
5.9 Backlight settings
Here you can set how the display backlight behaves when using V7 Navigation.
These settings are independent of the settings of the other applications of NAV700.
5.9.1 Brightness
You can set the backlight level separately for both daylight and night modes, thus
enhancing the effect of the night color scheme.
The values are between 0 and 10, where zero means there is no backlight at all, and
10 represents the maximum backlight value.
62