Operation Manual
14
again.
NOTE 1: Never introduce pre-ground coee when the machine is
o or it could spread through the inside of the appliance.
NOTE 2: Never add more than 1 measure, otherwise the applian-
ce will not make the coee.
NOTE 3: Use the measure provided only.
NOTE 4: Introduce only pre-ground coee for espresso coee
machines into the funnel.
NOTE 5: If more than one measure of pre-ground coee is used
and the funnel clogs, push the coee down with a knife (g. 21)
then remove and clean the infuser and machine as described in
the “Cleaning the infuser” chapter.
DELIVERING HOT WATER
• Makesurethewaterspoutisinplace(g.6).
• Position a container under the spout.
• Pressthe (B6) button (g. 20).
The message “HOT WATER” is displayed and hot water ows
out of the hot water spout into the container below.
You should not deliver hot water for more than 2 minutes at
a time.
To interrupt the ow, press the button (B6).
The appliance stops delivery once the set quantity is rea-
ched.
CHANGING THE QUANTITY OF HOT WATER
The appliance is set by default to automatically deliver 250 ml.
To modify these quantities, proceed as follows:
1. Position a container under the spout.
2. Press the button (B6) again until “HOT WATER PRO
GRAM QUANTITY” is displayed, then release the but-
ton.
3. When the hot water in the cup reaches the required level,
press the button (B6) again.
The machine is now reprogrammed with the new quantity.
MAKING CAPPUCCINO
• Selectthetasteofthecoeeyouwanttousetomakethe
cappuccino by pressing the button (B2).
• Removethelidofthemilkcontainer.
• Fillthecontainerwithabout100gramsofmilkforeach
cappuccino to be prepared (g. 23). Never exceed the MAX
level (corresponding to about 750 ml) marked on the con-
tainer.
You should ideally use skimmed or semi-skimmed milk at
refrigerator temperature (about 5°C).
• Makesuretheintaketubeiscorrectlyinsertedintherubber
washer (g. 24) then replace the milk container lid.
Position the froth regulator between the words cappuccino
and caelatte printed on the milk container lid.
The quantity of froth can be adjusted by moving the regula-
tor towards the word “caelatte” for a denser froth.
Moving it towards the word “cappuccino” obtains a less
dense froth.
• Removethehotwaterspout(g6)and attachthe milk
container to the nozzle (g. 25).
• Positionthemilktubeasshowning.26andthenplacea
sucientlylargecupunderthecoeeandmilkspouts.
• Press the button (B8). “CAPPUCCINO” is displayed
and after a few seconds, frothed milk ows out of the milk
spout into the cup below. (Delivery stops automatically).
• Theappliancedeliverscoee.
• Thecappuccinoisnowready.Sweetentotasteand,ifdesi-
red, sprinkle the froth with a little cocoa powder.
NOTE 1: While making cappuccino, the ow of frothed milk or
coee can be interrupted by pressing the button (B8).
NOTE 2: If the milk in the container nishes while delivering fro-
thed milk, remove the container and add milk.
Reattach and press the button (B8) to request a cappuccino
again.
NOTE 3: To ensure the complete cleanliness and hygiene of the
milk frother, always clean the circuits in the milk container lid
after making cappuccino. “PRESS CLEAN” ashes on the display.
• Placearecipientunderthemilkspout(g.26).
• PresstheCLEANbuttononthelid(C3)andholddownforat
least 5 seconds (g. 26) to start the cleaning function.
The appliance displays the message “CLEANING UNDER
WAY” above a progress bar. You should not release the CLE-
AN button until the bar is complete indicating that cleaning
is concluded. When the CLEAN button is released, the fun-
ction stops. After cleaning, remove the milk container and
place in the refrigerator. The milk should not be left out of
the refrigerator for more than 15 minutes.
NOTE 4: To change the quantity of coee or frothed milk the
appliance delivers automatically into the cup, proceed as descri-
bed in the section “Changing the quantity of milk and coee for
cappuccino”.
NO froth
“Less dense” froth
Froth regulator
“Denser” froth