Operation Manual

21
EN
DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION
FILL TANK The water tank is empty or
positioned incorrectly.
Fill the tank with water and/or insert it correctly,
pushing it as far as it will go.
GROUND TOO FINE ADJUST MILL
(alternating with)
PRESS OK
The grinding is too ne and the
coee is delivered too slowly.
Turn the grinding adjustment dial one click clockwise
towards “7”.
GROUND TOO FINE ADJUST MILL
(alternating with)
PRESS OK
(then)
FILL TANK
The tank has been removed during
delivery.
There is air in the hydraulic circuit.
Insert the tank and press the OK button (B4).
“HOT WATER PRESS OK” is displayed.
Press the OK button (B9) again.
The appliance is once again ready for use.
EMPTY GROUNDS CONTAINER The grounds container (A4) is too
full or more than three days have
passed since you last made coee
(this guarantees correct hygiene of
the machine).
Empty the grounds container and clean, then replace.
Important: when removing the drip tray, the grounds
container MUST be emptied, even if it contains few
grounds.
If this is not done, when you make the next coees, the
grounds container may ll up more than expected and
clog the machine.
INSERT GROUNDS CONTAINER After cleaning, the grounds container
has not been replaced.
Open the service door and insert the grounds
container.
ADD PRE-GROUND COFFEE The “pre-ground coee” function has
been selected without placing any
pre-ground coee in the funnel.
The funnel (A21) is blocked.
Extract the appliance and place pre-ground coee in
the funnel.
Empty the funnel with the help of a knife as described
in the section “Cleaning the pre-ground coee funnel”.
DESCALE
(alternating with)
COFFEE STANDARD
The machine must be descaled. The descaling procedure described in the “Descaling”
section needs to be performed as soon as possible.
LESS COFFEE Too much coee has been used. Select a milder taste or reduce the quantity of pre-
ground coee, then make the coee again.
FILL BEANS CONTAINER The coee beans have run out. Fill the beans container
INSERT INFUSER ASSEMBLY The infuser has not been replaced
after cleaning.
Insert the infuser as described in the section “Cleaning
the infuser”.
CLOSE DOOR The service door is open Close the service door.
GENERAL ALARM The inside of the appliance is very
dirty.
Clean the inside of the appliance thoroughly, as
described in the section “Cleaning and maintenance”.
If the message is still displayed after cleaning, contact
a service centre.
EMPTY CIRCUIT FILL CIRCUIT
alternating with
HOT WATER PRESS OK
The water circuit is empty Connect the hot water nozzle (A10) and press OK to
deliver water from it, until it ows out normally.