Operating instructions

7 Trouble-shooting
47
… the washing is not dry enough
… the programme takes significantly longer than indicated in the display
Possible cause Solution
• The load contains
different types of fabric.
➤ Select a longer programme.
➤ Select the programme.
➤ Change the level of dryness.
• An interruption in the
power supply.
➤ Plug in at the mains.
➤ Turn the mains switch on.
➤ Check the fuses.
• The moisture sensor is
dirty.
➤ Clean the moisture sensor.
• The demonstration mode
(dEno) is activated.
➤ Pull out and replace the mains connector
plug and then plug it in again.
If shows, clear the demonstration
mode with appliance door open and button
combination , and .
Possible cause Solution
• The following parts in the
appliance could be
blocked:
– Door filter
– Mesh filter in base
–Filter mat
➤ Check and, if necessary, clean the parts.
• Very wet washing.
➤ Spin washing at a higher speed.
• The ambient temperature
is too high.
➤ Improve the ventilation of the room.
MIN.