Operating instructions

7 Trouble-shooting
43
… flashes
… flashes
Possible cause Solution
• The moisture sensor is
dirty or wet.
➤ Clean the moisture sensor and then wipe
dry.
➤ Cancel the error message by pressing the
button.
➤ Start the programme.
➤ If the fault reappears, note down the
complete error message and FN number,
then switch off mains supply once more.
➤ Call Customer Services.
Possible cause Solution
• The following parts in the
appliance could be
blocked:
– Door filter
– Mesh filter in base
–Filter mat
➤ Check and, if necessary, clean the parts.
➤ Cancel the error message by pressing the
button.
➤ Start the programme.
➤ If the fault reappears, note down the
complete error message and FN number,
then switch off mains supply once more.
➤ Call Customer Services.
• The ambient temperature
is too high.
➤ Improve the ventilation of the room.
• The load is too wet/
heavy.
➤ Spin washing at a higher speed/reduce the
size of load.
Do not disregard this error message. Failure to observe it can cause
the appliance to become defective.