User's Manual

Table Of Contents

13 Technical data

13.1 Note for testing institutes

▸ The appliance must be connected to the electricity supply for at least 5 minutes be-

fore taking measurements.

▸ The declaration data can be determined correctly only after a run-in phase of 5 com-

plete drying programmes with washing (automatic programme: normal dry ).

▸ Wash the door filter each time after completing a drying programme.

▸ The moisture sensor of the appliance is calibrated based on average water hardness

levels. To adjust the water conductivity value of the appliance according to the norm

(750µS/cm), the level of dryness must be set to «1» in the user settings (see page

23).

▸ Set to the standard programme according to AS/NZS 2442.2:2000:

Programme Load

capacity

Work steps

Standard programme 7kg

▸ Press the button.

Data for the standard programme

Load capacity kg Programme duration

hrs./mins.

Energy star rating Energy consumption

kWh

7 3h30 1.40

13.2 Consumption values

Automatic programmes

The stated values for the programme duration and energy apply for the maximum stated

capacity with a wash spun at around 1200 rpm (corresponds to a moisture level of ap-

prox. 60%). A higher spin speed or a smaller load reduce them by approx. 20–30%.

Programme Load capacity

Remaining

moisture content

Programme

duration

hrs./mins.

Energy

kWh

Extra dry 1–7 -4 to -1 2h15 1.45

Normal dry 1–7 –1 to 2 1h55 1.30

Iron dry 1–7 8 to 16 1h35 0.99

Damp 1–7 20 to 30 1h20 0.74