Installation Guide

Installation instructions
«Front loader» washing machine
One-family household
1064373-06
22/10/2021
1064373-06
6
6. Plumbing in
Local water authority regulations must be observed.
Any old water supply and drain hoses must always be replaced with new hoses.
Water inlet
Only cold water G¾” permitted, possible pressure range: 0.1–1.0 MPa (1–10 bar).
The appliance must not be connected to a mixer tap or a continuous flow boiler!
1
A
Preferred alignment for Aquastop valve
blockA (sound-optimized installation):
▸ The tap seal seat must be clean and flat.
▸ Install hose without kinking or twisting it.
▸ Check for leaks.
Water outlet
When installing the drain hose, protect it against damage and kinks!
Installing the drain hose Work steps
Hose clamp
Drain hose A
Rubber connector
ø exterior 28.0 mm
ø interior 21.5 mm
1.5 m
▸ For drainage into fixed upright outflow
pipe, shorten drain hose A to necessary
length.
▸ For drainage into a bath tub or sink, etc.,
drain hose A cannot be shortened!
Drainage into an open-top fixed upright
outflow pipe
Drainage into a bath tub or sink, etc. Work steps
≤1200
≥350
B
A
≤700
A
B
▸ For all connection types, mount the hose
support B near but not to the appliance –
e.g. on a wall or hook.
▸ For drainage into a bath tub or sink, etc.,
secure the hose end with hose support
B.
Max. pumping height: 1200 mm Max. pumping height: 700 mm