2-WIRE INTERCOM SYSTEM User Instruction Public memory module Staircase light controller Extra cameras extended DT-ENG-SC6M-V1 P230509
Introduction The SC6M module is designed to DT system for the purpose of public memory sharing,staircase light control,and extra cameras extended. Note that the SC6M unit is just for the monitors that support the function only, it must use together with PC6 to support these functions, and one unit system just use one SC6M only. Terminal Description RS485 CAM1 CAM2 1 2 3 4 5 6 ON SETUP CN1 VD SETUP:DIP switches,refer to table 1 for detail information. RS485:Used to update program for SC6M.
Mounting Din rail Step1: Mount the din rail to the wall with screws ; Step2: Pull down the mounting buckle,then hang the unit on din rail.
Note: 1.the SC6M must connect together with PC6 to achieve these functions. 2. one unit system just need one SC6M only. 3. if the system connect SC6M, the picture memory function and calendar will be activated immediately. 4. if the switch is open, the light will be always on. if the switch is close, the light is controlled by the monitor. Picture Memory • The monitor of the system must support picture memory function. • Max.800 pictures is supported in SC6M.
1.
LED Indicator RUN LIGHT Description Blink Light on when setting the time for light MEMORY Light on when formating the SC6M memory CAMERA Light on when restore to default BUTTON PROG Description Press to quit program mode TURN ON Press to set the time for light In program mode,press TURN ON button, the LIGHT indicator will blink, timing is starting, press the TURN ON button again to confirm the time of light on.
The design and specifications can be changed without notice to the user. Right to interpret and copyright of this manual are preserved.
