Manual

5. Call Table For Blocks
For DT-IPC of blocks, there is 2 call tables for calling guard station: Button Call Table and
Call Priority.
The route for Call Table(Take B Block as an example): Click right mouse button on B Block
-> Management -> Call Table, see the following picture, both of them have 2 buttons, View
& Edit and View On Device. Press View & Edit, you can view the table in the database
and edit, then can download the edited table to the corresponding DT-IPC. Press View On
Device, you can check the call table in the corresponding DT-IPC.
Button Call Table: This table is for door station and monitors calling guard centre
The table is actually a Mapping between Guard Centre and Door station/Monitor.
It’s to say:
Fordoorstation,pressthespeciedbutton(DMR11)orinputthespeciedNo.(DMR18)to
call the corresponding Guard Centre.
For Monitors, press the specified No. in the Namelist to call the corresponding Guard
Centre.
1) View & Edit
Click Add Guard Centre button to pick one Guard Centre for 32
-54-
IP-2 wire system technical guide