Manual

Terminal description:
Item Name Description
Status indicator
LED202
Afterpoweronfor10s,itwillicker
Always on while working
LED203
DIP switches
SW201 Refer to DIP switches setting in followings
S201 Refer to DIP switches setting in followings
Network Signal Input
J701 RJ45 connection, connected to network.
Bus Signal Output
CN-BSO 2 wire terminal connection,to DT-DPS connection
Bus signal input
CN-BS1
2 wire terminal connection, to monitors or DBC4s
that monitors are connected
Bus signal input
CN-DS
Connected to door station or DBC4s that door
stations are connected
Prog Button
K201 Reserved
PC port
RS485
Set parameters of DT-IPC by PC that is connected
by RS485-USB Convertor
Power input: DC 24Vdc (supplied by DT-DPS)
Standby Current: 190 mA
Working Current: 250mA
VideoSignal:CCIR,1Vp-p,75Ω
Audio Signal: 300~3,400 KHz, 0~240 mV
Transmission Mode: TCP/IP
Connection Port: RJ45
Network Interface: Standard Ethernet interface
Working temperature: +5ºC ~ +40ºC
Dimension: 140(W)X60(H)X150(D)mm
2.2.3 Specicaon
-23-
IP-2 wire system technical guide