Owner's manual

Page 58
K5 System Technical Guide
4. Online Monitors search
Function: Search the certain range of Monitor which is for checking the information of the online
monitor. After startup this operation, the Door Station search and display the present online mon-
itor according to the setup range automatically. Operation steps are show as below:
5. Online Devices
This tool is used to identify whether C5-MDS, C5-IPC and C5-IMC are connected. When it is star-
tup, the connection states come out by turn automatically. If one of these devices is connected, it
shows online, otherwise, it shows ofine. Usually, this tool is used in project installation and main-
tenance.
Press #9008 then Installer
code to enter the Debug
mode, then 1# to enter
Tools page
Press #9008 then Installer
code to enter the Debug
mode, then 1# to enter
Tools page
Debug Tools menu is shown:
Press “4” to select
Debug Tools menu is shown:
Press “5” to select
Enter the starting number
and ending starting , and
# to start search the moni-
tors on line
The online devices status
will be checked immedi-
ately
> > D e b u g S t a t e < <
1 - # To o l s
0 - # R e d i a l
2 - # E x i t s
2 . S e t u p
4 . O n l i n e M o n i t o r s
5 . O n l i n e D e v i c e s
*Back
Tools
1 . I n s t a l l e r S e t u p
3 . C a r d M e m o r y
* Back # Save
(Search Range)
[ - - - - ] ~ [- - - - ]
4 . O n l i n e M o n i t o r s
> > D e b u g S t a t e < <
1 - # To o l s
0 - # R e d i a l
2 - # E x i t s
2 . S e t u p
4 . O n l i n e M o n i t o r s
5 . O n l i n e D e v i c e s
*Back
Tools
1 . I n s t a l l e r S e t u p
3 . C a r d M e m o r y
* Back # Save
MDS1 - - Offline
MDS2 - - Offline
MDS3 - - Online
MDS4 - - Offline
IPC - - Offline
IMC - - Offline
= = O n l i n e D e v i c e s = =
Chapter 4 K5 System Settings