Specifications

Page: 12
INTERNAL FUNCTIONS
F9 Sound Alarm for HI-OK-LO (nobEEP, gobEEP, HLbEEP,
HbEEP, LbEEP).
F10 Relay Output Mode Selection (Act L – open / close, Act H
open / close)
(F3) Weighing Unit Selection
a) Use the procedure described above to reach Function F3
b) Press MODE/RANGE to enter Function F3. The display
will show “on 0.X g” or “OFF 0.X g” (X value is the
division)
c) Press MODE/RANGE to enable/disable the selection of this
weighing unit by pressing MODE during normal
operation.
d) Press SAMPLE to shift between the different weighing
units available.
e) Repeat c) to d) for all the other weighing units.
f) In order to set the default weighing unit shown when the
scale is first turned on, press SAMPLE until the desired
weighing unit is shown then press ON/ZERO. The display
will show “InIt 0.X g”  “F4”. Turn off and then turn on
the scale to complete this process.
Page: 13
INTERNAL FUNCTIONS
(F4) Auto Power off Function
a) Use the procedure described above to reach Function F4
b) Press MODE/RANGE. The display will show “XX_oFF”
c) Press MODE/RANGE to select the Auto Power off time.
0_oFF  no auto power off
30 oFF  auto power off if not used in 30 minutes
d) Press TARE to confirm, then press ON/ZERO to return to
normal weighing mode.
(F5) Using RS-232 to connect to PC
a) Enter function F5.
b) Select Baud Rate by pressing SAMPLE.
br48
br96
br192
br 48  4800 bps
br 86  9600 bps
br 192  19200 bps