Specifications

Page: 6
KEYBOARD LAYOUT & FUNCTIONS
4- TARE
Press this key to tare off the weight of the load on the platter (full
tare available).
5- ON/ZERO
Press this key to turn on the scale or to manually set the display
to zero (can be used up to 2% of full capacity). Press and hold
this key to turn the backlight on / off.
6- MODE/RANGE
Press this key to change the weighing units/resolution and the
range of the HI-OK-LO. (When selecting weighing units or
resolution, press and hold this key until the desired weighing
unit and resolution is displayed).
Example for a 6kg SEK scale:
By pressing and holding the MODE key, it will shift between the
following weighing units and division:
6000.1 g  6000.2 g  6000.5 g  0.0000 lb  0’ 0.00 lb (lb-oz)
 0.0.0.0 Tael  PCS  6000.1 g  …
Page: 7
KEYBOARD LAYOUT & FUNCTIONS
When inputting HI-OK-LO value or a load is placed on the scale,
press and hold MODE/RANGE to set the displayed value as the
range for HI and LO values from the OK value. The LED for HI
and LO will light when the value is stored in the scale.
Remark: The weighing units can be turned on/off in the Function 3.
If the weighting unit is turned off, it will not be displayed by
pressing the MODE key.
7- MR
Press this key to recall the accumulated total weight or total
pieces.
8- M+
Press this key to accumulate the weight or pieces displayed into
the memory.
9- LOW LIMIT
When inputting the number using the numeric keypad or
placing a load on the scale, press this key to set the LO limit for
HI-OK-LO.(the LED for LO will light when the value is stored in
the scale)