Operation Manual

37
4 Setting Up (Oxy2, Pressure transmitter and Dive Computer)
II Uwatec
®
Aladin
®
Air Z O
2
English
II
4.3 Remarks about pairing
In order to be sure that Aladin
®
Air Z O
2
receives and uses the data of its own pressure transmitter, or Oxy2,
the units must be paired to each other.
Pairing is necessary:
– before the first use of Aladin
®
Air Z O
2
with the pressure transmitter or Oxy2.
– if you use a new pressure transmitter, Oxy2 or a new computer.
– after changing from a pressure transmitter to an Oxy2 or the reverse.
– after changing from a nitrox pressure transmitter to an air pressure transmitter
or the reverse.
– after changing the battery of the dive computer or pressure transmitter.
Oxy2 and Aladin
®
Air Z O
2
must be paired everytime you change from using a
pressure transmitter to an Oxy2 or the reverse!
– The pairing of a transmitter or Oxy2 with a dive computer remains valid until a
new pairing is carried out – the pairing can therefore be carried out at home. It
must in any event be done once before the system is first used. A new pairing
procedure is always necessary when a new transmitter, a new Oxy2 or a new
dive computer is used and after changing the battery of the dive computer or
pressure transmitter.
– Before every dive check that the lower part of the display shows either the tank
pressure (pressure transmitter) or the oxygen fraction (Oxy2).