Owner's manual

ColonyDoc-It Imaging Station 20
Creating Templates
Templates allow the user to set colony counting parameters so that plates with similar properties are counted
quickly and consistently.
To set a template for any Petri dish, choose Start Colony Count (or Restart Colony Count if the Petri dish has
been counted before) in the Colony Count module, then select the Manual Count function. A template can be
saved during operation Step 1 of 2: Select classes or Step 2 of 2: Finish.
To save a template in Step 1 of 2: Select
classes, add the desired points and classes if not
already selected) and click the New button in the
Template section of the window.
If additional information is needed, refer to the
Manual Count instructions in this manual.
A New Template pop-up window will ask for a
new Template name.
Type in the new name and select OK.
The Template name window will close and direct
back to the Step 1 of 2: Select classes tab.
Click on the Count button to proceed to the Step
2 of 2: Finish tab.