Owner manual

7. Printer and Security Dongle

Unpack the Thermal Printer (if purchased) and place this alongside the

computer. The printer is supplied with a separate instruction manual giving full

operation and service details. The printer driver is preloaded on computer

purchased with systems. If you need to install the driver onto a separate

computer, please see the end of this section.

You have been supplied with a printer cable that should be connected at one end

to the security dongle provided with the software, which is connected to the LPT1

parallel out-port of the computer, and into the Centronics port of the printer at the

other end. A power cable should be connected between the electrical supply and

the printer.

Power ON/OFF Press the switch at the top left-hand corner of the front

panel. The indicator light glows while the power is on.

Loading Paper 1. Ensure the power is ON.

2. Press the open/close button to open the paper lid.

3. Place the paper roll in the printer ensuring that the

thermosensitive side is up.

4. Pull out the first 15-20cm of paper to remove any slack in

the roll.

5. Press the open/close button to close the paper lid.

Receiving Indicator light for the receiving of transmission from the PC.

Paper Empty This indicator lights up when the printer has run out of paper.

Open/Close Press this button to open or close the door. It can also be

pressed to stop printing once it has been started.

Rear Controls The following connectors and controls are on the rear panel:

1. D ADJ Control (fine adjusting)

• Only used to make fine adjustments to the

density if you cannot control the brightness

with the Bright control.

2. DIP Switches

• Dip switches should be set to:

1. ON

2. ON

3. GAMA ON

4. GAMA ON

5. OFF

6. ON

7. OFF

8. ON

WWW.UVP.COM US Technical Support: 1.800.452.6788

UK Technical Support: +44.0.1223.420022