Manual

EL Series UV Lamps Page 6
Service Procedures
Return Procedure
A Returned Goods Authorization (RGA) number must be obtained from UVP Customer Service
before returning any product to UVP.
Replacing Tubes
 Disconnect the lamp from the electrical supply before replacing tubes.
 Remove the two Phillips head screws located in the end cap.
 Grasp the extruded housing and slide the chassis and filter out together away from the switch.
 Disconnect the interior Molex connector and slide the chassis and filter out from the housing
completely (Fig. 1).
 Once out of the extrusion, the chassis and filter will come apart.
 Carefully grasp the tube ends and twist one quarter turn until the tube works free (Fig. 2)
 Insert the new tube, twisting 90° to lock in place.
 Reconnect the interior Molex connector and reassemble the lamp. Do not pinch wires during
assembly.
Figure 2
Ground
Wire
Figure 1
Chassis
Filter
Housing
Molex
Connector
Screw