User`s manual

UTV500CC User’s Manual www.UTVsFactory.com
6
2. Main Driver：
Main driver： Tapered arc gear transmission，transmission rate： 33/9
3. Driving type： 4×4 front and rear wheels drive; Rear wheel is the normal
drive. Front wheel can be took off the driving. They are all the shaft
transmission。
4. Suspension：
Front suspension： swing arm type independent suspension.
Rear suspension： co-length double swing arm independent suspension, two
shock absorbers on each side of rear wheel.
5. Front Wheel alignment parameter：
Front wheel extroversion angle： 0° ±1°
Main pin inner obliquity： 11°50’ ±3°
Main pin back obliquity： 4°±1°
Front toe-in： -3—3mm
6. Tyre：
Front wheel： Front wheel type 25×8.00—12 Air inflating pressure：
250Kpa
Rear wheel：Tyre type 25×10.00—12 Air inflating pressure：
300Kpa
7. Steering system：
Adopt gear rack type redirector, total circle number of steering plate：3.75；
total swing angle of steering wheel：75°.
Maximum turning left: 37.5°.
Maximum turning right: 37.5°.
8. Brake：
Brakes adopt front and rear placement dual-pipeline hydraulic pressure brake
system, front and rear wheels adopt disk type brake. And parking brake adopts
mechanical transmission disk to work on the flange of the main axle of rear wheels.
9. Loading Dump Bed：
Dump Bed adopts slope backward by electric powered pump. Dumping angle
is 49°.
10. Winch:
Electric powered winch. Traction is 2000 pounds.
(V)、Electric apparatuses
1. Pipeline system： pipeline system adopts single-line system，Minus ground
strap， pipeline voltage is 12V。
2. Generator：out-rotor flywheel AC magneto，rated power is 325W。
3. Battery：voltage is 12V，capacity is 36A·h。