Owner`s manual

Control Functions 4-8
When riding on a flat road at a comparatively
high speed, adjust the settings to
“2WD/UNLOCK” and there are no symbols
in either of the 4WD indicators.
Riding an UTV while the differential is
functioning and is NOT locked, may improve
the stability and safety of the UTV operation.
CAUTION:
When the selector is set to 4WD, the right
4WD symbol front axle will have an ‘X’ in the
middle . When riding on good surfaces you
should unlock the differential and press in
the yellow and the gray buttons to the 2WD
unlocked position. There should be no
symbols showing in either the left or right
4WD indicators.
CAUTION:
If the display indicators flash or the
speedometer does not show the speed while
the UTV is in motion, Ask a dealer to check
the speed sensor and circuits.
Fault code indicator
When the EFI encounters faults, the ECU will
send the fault code to the instrument display,
and it will flash on the clock.
If there are more than one fault code, they
will be shown in rolling sequence. When
fault codes are present, in order to see the
time press the clock button, the time will be
shown. Then after five seconds, the fault
code returns again. Only after the fault is