Installation Sheet

ASSEMBLY INSTRUCTIONS
22527
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
WE SUGGEST A LICENSED ELECTRICIAN FOR ALL FIXTURE INSTALLATIONS.
Installation Steps
1. Carefully unpack your new fixture and lay out all
the parts on a clear surface.
2. Thread the Mounting screws into the matching holes
of the Mounting bar, and tighten with the Hex nut.
Thread the Ground screw into the hole of the
Mounting bar. Secure the Mounting bar to the outlet
box with the Outlet box screws.
3. Make Wire connections with Wire Connector:
---The smooth wire (w/ marking) from fixture to
Black Wire from power source.
---The ribbed wire (w/o marking) from Fixture to
White Wire from power source.
---Attach the Ground Wire and house ground
wire to the Mounting bar with the green Ground
screw.
Carefully tuck wires back into the Outlet Box.
4. Place the fixture Back plate over the two Mounting screws so they protrude through the holes in the
Back plate. Thread the Ball nut onto the Mounting screws and continue turning until the fixture is
snug against the ceiling.
5. Install the Glass shade into the Socket, then secure them with the Socket ring.
6. Install the light bulb in accordance with the fixture’s specifications.
DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
7. Turn on the power at fuse or Circuit Box.
PO BOX 558/3325 GRASSY HILL RD. ROCKY MOUNT, VIRGINIA 24151
www.uttermost.com
WARNING:
G LA SS SH A D E
SO C K ET R IN G
SO C K ET
H EX N U T
M O U N TIN G SC R EW
M O U N TIN G B A R
G R EEN G R O U N D
SC R EW
O U TLET B O X SC R EW
O U TLET B O X
B A LL N U T
B A C K PLA TE