Installation Sheet

ASSEMBLY INSTRUCTIONS
STYLE
#:
21517
Carefully unpack all lamp parts from carton.We suggest a licensed electrician for all fixture installations.
1
.
Take the lamp carefully out of the Carton,and place on a flat surface.
2
. Be sure power to the installation point is OFF.Follow the steps below for assembly.
3
. Adjust the length of wire needed for your installation, remove excess. Determine the number of
Rods
to be assembled to the
Fixture Body
as needed for your hanging height.Pull the Supply Wire with Ground Wire through the selected
Rods
and
Loop
and
Quick Link
. Thread the
Rods
& connect
Nipple
. Hand tighten.
4
. Attach one end of the
Quick Link#1
and
Loop#1
on the bottom of
Canopy
,and then attach the other end of the
Quick Link#2
onto the
Rods
.
5.
Secure the
Crossbar
to the outlet box with outletbox screws. Tighten until snug.
6
. Connect the wire as shown.
a
.Connect the House Ground Wire to the Fixture Ground Wire, secure with wire nut.
b.
Connect the House White (or Ribbed) Wire to the Fixture Supply Wire (White or Ribbed Side),secure with wire nut.
c.
Connect the House Black (or Red) Wire to the Fixture Supply Wire (Black or Smooth Side),secure with wire nut.
d.
Carefully stuff all of the connected wires into the Outlet Box.
7
. Install the correct
Bulb
(Not Included) into the
Socket
until snug.
PO BOX 558/3325 GRASSY HILL RD. ROCKY MOUNT, VIRGINIA 24151
www.uttermost.com
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.