Installation Sheet

ASSEMBLY INSTRUCTIONS
21336
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
WE SUGGEST A LICENSED ELECTRICIAN FOR ALL FIXTURE INSTALLATIONS.
Installation Steps
1. Carefully unpack your new fixture and lay out all the
parts on a clear surface.
2. Adjust wire length as needed for your installation
removing excess. Select stem lengths needed
for your installation. Assemble the Stem together
using the Nipple, then attach the bottom end of
Stem onto the Coupling tightly, then secure the
Loop onto the Stem. Set the position of the Loop
and lock the Loop position with wrench.
3. Attach the Loop on the stem to the canopy Loop
by using the quick link.
4. Thread the Mounting screws into the matching holes
of the Back plate, and tighten with the Hex nut.
Thread the Ground screw into the hole of the Back
plate. Secure the Back plate to the outlet box with the
Outlet box screws. Thread the Wood screw into the
hole of the Back plate .Secure the Back plate to the
Plastic anchor.
5. Make Wire connections with Wire Connector:
---The smooth wire (w/ marking) from fixture to
Black Wire from power source.
---The ribbed wire (w/o marking) from Fixture to
White Wire from power source.
---Attach the Ground Wire and house ground wire to the Mounting bar with the green Ground screw.
Carefully tuck wires back into the Outlet Box.
6. Place the fixture Canopy over the two Mounting screws so they protrude through the holes in the
Canopy. Thread the Ball nut onto the Mounting screws and continue turning until the fixture is snug
against the ceiling.
7. Install the Glass shade into the Socket, then secure them with the Socket ring.
8. Install the light bulb in accordance with the fixture’s specifications.
DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
9. Turn on the power at fuse or Circuit Box.
PO BOX 558/3325 GRASSY HILL RD. ROCKY MOUNT, VIRGINIA 24151
www.uttermost.com
WARNING:
STEM
C O U PLIN G
N IPPLE
LO O P
G L A SS SH A D E
SO CK ET RIN G
SO CK ET