Installation Guide

D
C
B
1PC
Crystal finial
R.
WARNING: BEFORE INSTALLING Make sure electricity supply is
shut off to avoid a possible electric shock.
2PCS
1PC
2PCS
1PC
1PC
1PC
1PC
1PC
2PCS
1PC
39PCS
39PCS
102PCS
STYLE NO:21138
Parts and Hardware List
A.
B.
C.
D.
E.
F.
G.
H.
I.
J.
K.
L.
M.
Glass sticks
Cross Bar
Outlet box screws
Pre-Threaded Pipe
Hex Nut
Pre-Threaded Ring
Collar loop
Canopy
Wire Nut
Chain
Quick Link
Please read wiring Instructions before you begin assembling
and installing your Chandelier.
Assembly Instructions
1.Carefully remove the parts and hardware from the carton.
2.Fasten the Cross Bar (O) to the outlet box using the Outlet box Screws.
3.Insert the shorter end of the Pre-Threaded Pipe (F) into the pre-drilled hole in
the Cross Bar(O) and secure with the Hex Nut(G).See Illustration.
4.Attach the Collar Loop (I) to the exposed end of the Pre-Threaded Pipe (F)and
secure by turning in a clockwise direction.
5.Attach the Quick Link on other end of the Chain(L) to Collar Loop (I).
6. Slip the Pre-Threaded Ring(H) first and then the Canopy (J) over the other end
of the Chain (L)
7. Attach the other Quick Link on other end of the Chain (L)to the loop on the top
of Chandelier Assembly (A).
8. Lace the wire through the chain ,through the collar loop and up through the
Pre-Threaded Pipe(F) See Illustration.
9. Place the white ,ribbed or tinted wire evenly against the white wire from the
outlet box and place the black,smooth or un-tinted wire evenly against the black
wire from the outlet box (Connecting the Wires-See Figure2)
10.Install the ground wire in the Cross Bar with the green screw supplied.
11. After the wires are connected,tuck them carefully inside the outlet box ,Place
Canopy (J) over the outlet box and secure with Pre-Threaded Ring(H).
12. Hanging the glass sticks and crystal beads from inside to outside in turn of A
to D, Crystal B and C are hang in the same metal ring one by one.
13.Screw the pipe nipple clockwise to coupling nut until secure.
14.Attach the shutter in the pipe nipple the secure by Crystal finial turning a
clockwise direction.
15.Install 60 Watt, Type B bulbs (sold separately) into the sockets of the fixture.
Notice:
Please hang the crystal ball to the end of crystal strand when it droped out of the
strand.
If the fixture hanging crystal can't be on a level,please note the three weights on
the frame in the tube are moveable ,they are used to balance and make the fixture
hang level.
Square bead
Please make sure that you have all the parts indicated before you
begin assembly of this item.
M
L
K
G F
H
I
J
R
O
M
ILLUSTRATION
STYLE#: 21138
Threaded Pipe
Outlet box screw
Ground Wire
Cross Bar
Collar loop
Bulb
Q
B图
A
N
Q.
P.
O.
N.
LOOP
Pipe nipple
Shutter
1PC
39PCS
1PC
Square bead and crystal ball (long)
Square bead and crystal ball (short)
1PC
coupling nut