Specifications

UTT Technologies Chapter 6 Wireless
http://www.uttglobal.com Page 80
Wireless Router automatically select the best channel. If there are multiple wireless
routers in your area, please make sure that their channels don’t interfere with each
other.
Channel Width: It specifies the range of frequecies used by your wireless network.
The options are 20/40M and 20M. Note that this parameter can only act on 802.11n
wireless clients. 802.11b and 802.11g wireless clients can only use 20MHz channel.
● 20M/40M: If you select this option, 802.11n wireless clients will negotiate the
channel width with the Wireless Router.
● 20M: It you select this option, 802.11n wireless clients will use 20MHz channel.
Enable SSID Broadcast: It allows you to enable or disable SSID broadcast. If you
select the check box to enable this feaute, the Wireless Router will periodically
broadcast its SSID, so that wireless clients can automatically find it to connect to the
Wireless Router and join the wireless network identified by the SSID. However, this
feature also makes it easier for hackers to know your SSID and break into your
WLAN. It is suggested that you disable this feature to improve security of your WLAN.
In this case, you need to manually configure the right SSID for your wireless clients.
Save: Click to save your changes.
Cancel: Click to revert to the last saved settings.
6.1.2 APClient Mode
If you want the Wireless Router to operate in APClient mode, please select APClient
Mode from the Opeartion Mode drop-down list, see Figure 6-2. In this mode, the
Wireless Router can connect to a remote network device in AP mode, and at same time it
can provide connectivity for wireless clients.
If you configure the APClient Internet connection in the Start > Setup Wizard, the system
will automatically choose APClient Mode as the Operation Mode.