Specifications

UTT Technologies Chapter 5 Network
http://www.uttglobal.com Page 68
5.4.5 Configuration Example for DHCP
1. Requirements
In this example, the Wireless Router acts as a DHCP server to dynamically assign the IP
addresses to the clients that reside on the same subnet. The Wireless Router’s LAN IP
address is 192.168.1.1/24. The start IP address of the DHCP address pool is
192.168.1.11, and the number of addresses is 100.
Besides, there are two computers that must always have the same IP address: one’s MAC
address is 00:21:85:9B:45:46 and IP address is 192.168.1.15, the other’s MAC address is
00:1f:3c:0f:07:f4 and IP address is 192.168.1.16.
2. Configuration Steps
Step 1 Go to the Network > DHCP Server > DHCP Server Settings page.
Step 2 As shown in the following figure, select the Enable DHCP Server check box,
and enter 192.168.1.11 and 192.168.1.110 in the Start IP Address and End IP
Address text boxes respectively. Leave the other parameters at their default
values. Then click the Save button to save the settings.