Specifications

UTT Technologies Chapter 5 Network
http://www.uttglobal.com Page 60
5.3 LAN Settings
This section describes the Network > LAN page, where you can configure the IP address,
subnet mask and MAC address of the Wireless Router’s LAN interface.
Figure 5-16 LAN Interface Settings
IP Address: It specifies the IP address of the LAN interface.
Subnet Mask: It specifies the subnet mask that defines the range of the LAN.
MAC Address: It specifies the MAC address of the LAN interface. In most cases,
please leave the default value.
Interface Mode: It specifies the speed and duplex mode of the WAN interface. The
Device supports five modes, which include Auto (Auto-negotiation), 100M-FD (100M
Full-Duplex), 100M-HD (100M Half-Duplex), 10M-FD (10M Full-Duplex), and 10M-HD
(10M Half-Duplex). In most cases, please leave the default value. If a compatibility
problem occurred, or the network device connected to the WAN interface doesn’t
support auto-negotiation function, you may modify it as required.
Advanced Options: Click it to view and configure advanced parameters. In most
cases, you need not configure them.
IP Address 2: It specifies the secondary IP address of the LAN interface.
Subnet Mask 2: It specifies the secondary subnet mask that defines the range of the
secondary subnet.