Specifications

UTT Technologies Chapter 5 Network
http://www.uttglobal.com Page 48
Advanced Options: Click it to view and configure advanced parameters. In most
cases, you need not configure them.
Mode: It specifies the mode of the device, including Pure Route Mode and NAT
Mode. It is NAT Mode by default.
Pure Route Mode: The device just has the routing function. It doesnt translate
the interal IP address to the external IP address.
NAT Mode: The device enables NAT function.
MAC Address: It specifies the MAC address of the WAN interface. In most cases,
please leave the default value.
Interface Mode: It specifies the speed and duplex mode of the WAN interface. The
Device supports five modes, which include Auto (Auto-negotiation), 100M-FD (100M
Full-Duplex), 100M-HD (100M Half-Duplex), 10M-FD (10M Full-Duplex), and 10M-HD
(10M Half-Duplex). In most cases, please leave the default value. If a compatibility
problem occurred, or the network device connected to the WAN interface doesnt
support auto-negotiation function, you may modify it as required.
Save: Click to save your changes.
Cancel: Click to revert to the last saved settings.
5.1.2.1.2 DHCP Internet Connection Settings
Figure 5-7 DHCP Internet Connection Settings
Interface: It specifies the name of the WAN interface. Here please select WAN1,
WAN2 or APClient.
Connection Type: It specifies the type of the Internet connection. Here please select
DHCP. The Wireless Router will automatically obtain the WAN IP address, subnet
mask and gateway and DNS server addresses from your ISPs DHCP server.