Specifications

UTT Technologies Chapter 3 Quick Setup
http://www.uttglobal.com Page 26
Figure 3-7 Setup Wizard - WAN1/WAN2 Internet Connection Settings (Static IP)
Connection Type: It specifies the type of the Internet connection. Here please select
Static IP. You need to manually configure IP address, subnet mask, default gateway
and DNS server addresses, which are provided by your ISP.
IP Address: It specifies the IP address of the WAN interface, which is provided by
your ISP.
Subnet Mask: It specifies the subnet mask of the WAN interface, which is provided
by your ISP.
Default Gateway: It specifies the IP address of the default gateway, which is
provided by your ISP.
Primary DNS Server: It specifies the IP address of your ISP’s primary DNS server.
Secondary DNS Server: It specifies the IP address of your ISP’s secondary DNS
server. If it is available, you may set it. Else, please leave it blank.
Back: Click to go back to the previous page of the Setup Wizard.
Cancel: Click to revert to the last saved settings.
Exit: Click to exit the Setup Wizard and go to the Welcome page (see Figure 3-5).
The changes made in the Setup Wizard will be discarded.
Skip: Click to go directly to the next page of the Setup Wizard. The changes made
on the current page will be discarded.
Next: Click to go to the next page of the Setup Wizard.
Note
The WAN IP address and default gateway IP address must be on the same subnet. If
not, please modify the Subnet Mask to make them be on the same subnet. If you
don’t have the subnet related knowledge, please ask a professional or UTT customer
engineer for help.
3.3.3.1.2 DHCP Internet Connection Settings
If your ISP automatically assigns an IP address to the Wireless Router via DHCP, please
select DHCP from the Connection Type drop-down list. Then the following page will be
shown.