Specifications

UTT Technologies Appendix B FAQ
http://www.uttglobal.com Page 271
Step 3 Configure the DHCP Internet connection related parameters in the Start >
Setup Wizard or the Network > WAN page.
Note
Some ISPs register the MAC address of your network device (usually a computer)
when your account is first opened, and they will only accept traffic from that MAC
address. In this case, you need to change the new Router’s MAC address to the
registered MAC address. The operation is as follows: Go to the Network > WAN
page, select the MAC Address Clone tab, and then change the MAC address of the
corresponding interface, lastly click the Save button.
Step 4 After the DHCP Internet connection is established successfully, you can go to
the view its configuration and status information in the Internet Connection
List on the Network > WAN page, such as Status (Connected means the
connection is established successfully), the connection’s IP address and
Gateway assigned by your ISP, Tx Rate, Rx Rate, and so on, see Figure
B-0-4.
Figure B-0-3 Viewing DHCP Connection Status in the Internet Connection List
Figure B-0-4 Viewing DHCP Connection Status in the Internet Connection List (Continue)
Step 6 Configure the local computers according to the steps described in Appendix A
How to Configure Your PC.