Specifications

UTT Technologies Appendix B FAQ
http://www.uttglobal.com Page 269
Appendix B FAQ
1. How to connect the Wireless Router to the Internet
using PPPoE?
Step 1 Set your ADSL Modem to bridge mode (RFC 1483 bridged mode).
Step 2 Please make sure that your PPPoE Internet connection use standard dial-type.
You may use Windows XP built-in PPPoE dial-in client to test.
Step 3 Connect a network cable from the ADSL modem to a WAN port of the Wireless
Router, and connect your telephone line to the ADSL modem’s line port.
Step 4 Configure the PPPoE Internet connection related parameters in the Start >
Setup Wizard or the Network > WAN page.
Step 5 If you pay monthly for the Internet connection, you can choose Always On as
the Dial Type; else, you can choose On Demand or Manual as the Dial Type,
and specify the Idle Timeout to avoid wasting online time due to that you forget
to hang up the connection in time.
Step 6 If you choose Manual as the Dial Type, you need to dial up manually in the
Internet Connection List on the Network > WAN page. Refer to Section
5.1.1.3 for more information.
Step 7 After the PPPoE connection is established successfully, you can view its
configuration and status information in the Internet Connection List on the
Network > WAN page, such as Status (Connected means that the connection
is established successfully), the connection’s IP address and Gateway
assigned by your ISP, Tx Rate, Rx Rate, and so on, see Figure B-0-1.
Figure B-0-1 Viewing PPPoE Connection Status in the Internet Connection List