Specifications

UTT Technologies Chapter 12 VPN
http://www.uttglobal.com Page 231
Figure 12-23 IPSec Settings (AutoKey (IKE) – Originate-Only)
The parameters Gateway IP/Domain Name (Remote), Subnet IP (Remote), Subnet
Mask (Remote), Bind to (Local), Subnet IP (Local), Subnet Mask (Local), Preshared
Key, and P2 Encrypt/Auth Algorithms 1 are the same as those in the Bidirectional
connection type, please refer to the detailed descriptions of them.
The difference is that this connection type requires identity authentication. Specifically, the
identity authentication for the local UTT gateway is required, that is, the local UTT
gateway should provide its identity information to the remote IPSec endpoint for
authentication; but the identity authentication for the remote IPSec endpoint is optional.
ID Type (Remote): It specifies the type of remote ID. The available options are
Domain Name, Email Address, IP Address and Other. In this connection type, it is
an optional parameter. If you want remote IPSec device to be authenticated, please
select one type and then specify ID Value (Remote).
ID Value (Remote): It specifies the identity of the remote IPSec device. In this
connection type, it is an optional parameter. Please enter an ID value according to the
selected ID Type (Remote).