Specifications

UTT Technologies Chapter 10 QoS
http://www.uttglobal.com Page 175
Note
1. The P2P rate limit has higher priority than the rate limit rules configured in the QoS >
FixedRate Limiting Rule page.
2. Only after you have enabled rate limit in the QoS > Global Settings page, the P2P
rate limit settings can take effect.
10.4 Session Limiting
This section describes QoS > Session Limiting page.
The Session Limiting feature allows you to limit the maximum number of concurrent
Sessions per host, including maximum total Sessions, maximum TCP Sessions,
maximum UDP Sessions, and maximum ICMP Sessions.
Figure 10-5 Session Limiting
Enable Session Limit: Select the check box to enable connection limit.
Max. Sessions: Enter the maximum number of Sessions allowed per host. The default is
1500.
Max. TCP Sessions: Enter the maximum number of TCP Sessions allowed per host. The
default is 1000.
Max. UDP Sessions: Enter the maximum number of UDP Sessions allowed per host. The
default is 800.
Max. ICMP Sessions: Enter the maximum number of ICMP Sessions allowed per host.
The default is 100.