User guide

¾ Go to Connections tab and click on LAN Settings.

¾ Make sure that all the options are un-checked.

¾ Click on OK and close the Internet Options window.

¾ Close the Browser.

¾ Also verify the following TCP / IP Settings.

Go to My Computer - > Control Panel - > Network Connections –

> Right Click your LAN connection Icon where D-Link device is indicated. Select

Properties.

Under tab General, Select Internet Protocol (TCP/IP) - > Properties - >

In the TCP / IP properties window the following should be selected and entered–

• Obtain IP automatically

• DNS Server Address as : Preferred DNS (Primary) 59.179.243.70

Alternate DNS (Secondary) : 203.94.243.70

• Click OK.

Reboot the PC (If prompted. Otherwise PC Reboot is not required)

Verify connectivity by running PING test as explained above.

(ii) Verify connectivity between ADSL2+ CPE and Broadband Network -

To verify the above connectivity, open the management interface of ADSL CPE by starting your browser

(Internet Explorer) and opening the webpage –

http://192.168.1.1.

Give- admin as username and admin as password to open the ADSL CPE Management Page

Note – DO NOT CHANGE ANY SETTINGS UNLESS ADVISED. USE THIS INTERFACE FOR

DIAGNOSTICS PURPOSES ONLY.

Select the Status TAB. The following indicates proper connectivity-

¾ In WAN Section, the Status should be shown as Connected.

¾ IP Address should be allotted. The Format shall be 59.1xx.x.x

¾ Default Gateway should be allotted. The format shall be 59.1xx.x.x

¾ DNS Server should be allotted.

Note the above addresses and perform PING test on them to verify connectivity to broadband network.

If the Status of WAN connection is Disconnected, it indicates a possible Network or Password

problem.

In case the password has been changed recently, verify that the password has been set properly (Refer

Password Section).

If still the status is disconnected, register your complaint with MTNL Broadband Helpdesk at 1504

or 22221504.