Technical data
Table Of Contents
- iAN-02EX Release 1.0 Administrator Manual Issue 1.7
- Contents
- List of Tables
- List of Figures
- About This Guide
- Overview
- Hardware Installation
- Technical Specification
- Configuring TCP/IP Protocol
- Configuration
- Troubleshooting
- iAN-02EX Provisioning Methodology
- Provisioning overview
- Provisioning Features
- Provisioning Process rules
- Auto-Configuration
- Brief description on HTTP/TFTP Provisioning servers
- HTTP Provisioning servers
- Selection Prority for HTTP or TFTP servers
- Frequency of Upgrade
- Provisioning Server configuration files
- File format of the configuration File
- Encryption Engine
- Firmware Upgrade
- Provisioning Default Values
- UTStarcom, Provisioning Default Flag Values
- Sample Provisioning Flow Behavior
- Provisioning Flow
- Default Setting & Value
- iAN-02EX SNMP MIB Reference
- Upgrade Procedure
92
Chapter 5: Configuration
iAN-02EX
Part Number UTSI-NJTC-200323150117
Administrator Manual
June 2005
From the ATA simply dial *#
322867973738
. The ATA will restore the default
settings and reboot automatically.
This access is pre-configured on the ATA and cannot be changed. After reboot,
the ATA will restore the default values. This is useful in the event of the service
operator is unable to telnet or access the Web-base management of the ATA.
This feature is available even if network is not available on the ATA.
Load Default Keypad
Click
Load Default Keypad
in the
Save
section. Figure 72 prompts for
configuration.
Figure 72
Save - Load Default Keypad
Configure the parameters accordingly. Click
OK
to confirm the modification or
click
Cancel
to discard the modification.
Save
the configuration and Reboot the module for the new configuration to take
effect.
Reboot
Reboot
Click
Reboot
in the
Reboot
section. Figure 73 prompts for confirmation.
Figure 73
Reboot - Reboot