Technical data
Table Of Contents
- iAN-02EX Release 1.0 Administrator Manual Issue 1.7
- Contents
- List of Tables
- List of Figures
- About This Guide
- Overview
- Hardware Installation
- Technical Specification
- Configuring TCP/IP Protocol
- Configuration
- Troubleshooting
- iAN-02EX Provisioning Methodology
- Provisioning overview
- Provisioning Features
- Provisioning Process rules
- Auto-Configuration
- Brief description on HTTP/TFTP Provisioning servers
- HTTP Provisioning servers
- Selection Prority for HTTP or TFTP servers
- Frequency of Upgrade
- Provisioning Server configuration files
- File format of the configuration File
- Encryption Engine
- Firmware Upgrade
- Provisioning Default Values
- UTStarcom, Provisioning Default Flag Values
- Sample Provisioning Flow Behavior
- Provisioning Flow
- Default Setting & Value
- iAN-02EX SNMP MIB Reference
- Upgrade Procedure
86
Chapter 5: Configuration
iAN-02EX
Part Number UTSI-NJTC-200323150117
Administrator Manual
June 2005
Configure the parameters accordingly. Click
OK
to confirm the modification or
click
Cancel
to discard the modification. Figure 62 prompts for modification
confirmation.
Figure 62
Password - User Password - Confirmation
Click
OK
in Figure 62. If currently the ATA is in user mode, the system requires
the user to re-login with the new user password as shown in Figure 63
. Enter the
new password and click
OK
to login.
Figure 63
Password - User Password - Re-login
Save
the configuration and Reboot the module for the new configuration to take
effect.
Note: The password will be used for authentication. It is strongly recommended
that the user resets the default password for administrative security.
Note: The default user password is
12345
.