Technical data
Table Of Contents
- iAN-02EX Release 1.0 Administrator Manual Issue 1.7
- Contents
- List of Tables
- List of Figures
- About This Guide
- Overview
- Hardware Installation
- Technical Specification
- Configuring TCP/IP Protocol
- Configuration
- Troubleshooting
- iAN-02EX Provisioning Methodology
- Provisioning overview
- Provisioning Features
- Provisioning Process rules
- Auto-Configuration
- Brief description on HTTP/TFTP Provisioning servers
- HTTP Provisioning servers
- Selection Prority for HTTP or TFTP servers
- Frequency of Upgrade
- Provisioning Server configuration files
- File format of the configuration File
- Encryption Engine
- Firmware Upgrade
- Provisioning Default Values
- UTStarcom, Provisioning Default Flag Values
- Sample Provisioning Flow Behavior
- Provisioning Flow
- Default Setting & Value
- iAN-02EX SNMP MIB Reference
- Upgrade Procedure
116
A
PPENDIX
B:
I
AN-02EX P
ROVISIONING
M
ETHODOLOGY
iAN-02EX
Part Number UTSI-NJTC-200323150117
Administrator Manual
June 2005
ATA will look for general, group (currently disabled) and MAC [Encrypted]
configuration file from the HTTP server. If these files are received by the ATA the
subsequent TFTP configuration file search is stopped.
3
Step3:
Once these files are received the ATA will compare the configuration within the
ATA and reboot to assume the new configuration.
4
Step4:
After the completion of configuration file update, the ATA will recheck the
3-configuration files status and proceed for the Upgrade firmware process. The
ATA will check the current firmware version and if required will download the
new firmware and reboot when the download is complete.
5
Step5:
If the HTTP server is not available for some reason the system will go into the
TFTP configuraiton file provisioning.
During this operation the ATA will look for the 3 configuration files on each port.
If the configuraiton file is available on one port the same configuration file is not
tried again on subsequent ports.
If the port value is zero on any given port then that particular port will not be
tried.
Once these files are received the ATA will compare the configuration within the
ATA and reboot to assume the new configuration.
6
Step6:
After the completion of configuration file update(s), the ATA will recheck the 3-
configuration files status and proceed for the Upgrade firmware process. The
ATA will check the current firmware version and if required will download the
new firmware and reboot when the download is complete.