User's Manual

Chapter 4 Web-based Configuration 41
WA3001-S Access Point User Guide
• Add a MAC address to static MAC table: Add MAC addresses to the
MAC address table, two available ports, WLAN1/WLAN2. Click <Add>
after the configuration.
• MAC table entries: Display MAC entries.
VLAN Configuration
Click “Advanced Config/VLAN”, the configuration user interface is shown in
Figure 58. VLAN ID used for differentiating users access levels depends on
access privilege. E.g. Administrators and Guests are two different groups of
users depends on their VLAN ID.
Figure 58 VLAN Configuration
• Enable VLAN: Enable the AP’s VLAN function
• To differentiate the user access privilege by enabling the VLAN tag.
• VLAN mode: Three modes are available. They are “User based”, “Port
based” and “Mix”.
• User based VID
- Default VID: The possible value are 1-4094, the default is 1.
- Employee default VID: The VLAN ID used for company employees
to access network. The possible values are 1-4094. The default
value is 1000.
- Guest default VID: The VLAN ID used for guests to access network.
The possible values are 1-4094. The default value is 4000.
• Port based VID: The usable WLAN port (WLAN1/WLAN2) is displayed
on the screen. Configure the WLAN port VLAN ID, the possible values
are 1-4094, the default value is 1.
Click <Apply> to take the configuration effect, the “VLAN bounding table”
displays the current users information bounding with VLAN.
System Configuration
WA6011 provides password change, AP Management and Upgrade in
System Configuration.