User's Manual
36 Chapter 4 Web-based Configuration
User Guide WA3001-S Access Point
Figure 46 Initial a Specific User Configuration
Select a “User ID”, click <Initial>, the user’s information will be initialized.
• Re-authenticate a specific user configuration interface is shown in
Figure 47
Figure 47 Re-authenticate a Specific User Configuration
Select user ID, click <Reauth>, AP starts the re-authentication for the user
Subscriber Configuration
Click “Advanced Config/Subscriber”, the dynamic subscriber configuration
interface is shown in Figure 48.
Figure 48 Subscriber Configuration
• Create a dynamic user
Enter User name and Password as shown in Figure 48, and then click
<Add>. A new entry will be added in the table as shown in Figure 49. Select
a status of enable/disable/delete, click <Apply> to take the configuration
effect.
Figure 49 Dynamic User Table