User's Manual

Chapter 4 Web-based Configuration 23
WA3001-S Access Point User Guide
Note: When the 108g mode is selected, the “108g optimization”
parameter option in “Advance Config/Wireless Port Config” has to be
activated. See Figure 24
Figure 24 108g Optimisation Parameter Configuration
In addition, the wireless network card should support 108g to implement
108g mode, e.g. UTStarcom WNIC2010 Wireless Network Card. See Figure
25, select the “Turbo G” function in the “Advance” option menu in WNIC2010
Utility Settings.
Figure 25 Set WNIC2010 to Enable Turbo G Mode
- ESSID: Each AP can be set with a specific ESSID (or they can be
set the same), also each wireless card can be set with a specific
ESSID. The AP only accepts wireless access when the ESSID of
the wireless card matches the AP’s ESSID. Specific ESSIDs can be
used for grouping users to avoid security and access problems
arising from random roaming. the default ESSID of WA6011 is “UT”,
but other ESSIDs are accepted between 1-32 characters. Click
<Apply>, the system will prompt to save the configuration and
reboot the AP.
- Frequency Channel: The Channel can be set in the range of 1-13.
The default is 1.
Note: The Frequency Channel is fixed to 6 by the system when
the Mode is “Dynamic G” or 108g.
• WEP Configuration