User's Manual

10 Chapter 2 Hardware Installation
User Guide WA3001-S Access Point
Name Description
MODEL NO WA6012
P CODE
Product Code:
O: outdoor
E: Ethernet port
A: ADSL port for WA6012
400400mw power
A: AC power supply
D: PoE
2: Support b/g mode
3: Supports a/b/g mode. A
supplementary digit represents
two network cards installed.
S/N Serial number
MAC ADDR Device MAC address
Cable Connection
WA6011/6012 are outdoor AP, its rack installation, please refer to
WA6011/6012 Outdoor AP Installation Guide. The cable connection will
be described in this section.
WA6011 in AP mode:
AC power supply
1 Connect the 220V AC power adapter to the AC power supply
2 Connect the DATA interface in AP to the Internet (usually is a port of an
Ethernet switch) through a data cable
3 Configure the wireless network card for wireless users access
PoE power supply
1 Connect the 220V power connection socket on PoE module to the AC
power supply through a power cable
2 Connect the Input jack in PoE module to the internet (usually is a port of
an Ethernet switch) through an Ethernet cable
3 Connect the DATA interface in AP to the Output interface in PoE
module through a data cable, the cable provides data transmission and
DC power
4 Configure the wireless network card for wireless users access
WA6012 in AP mode:
1 Connect the 220V AC power adapter to the AC power supply
2 Connect the DATA (ADSL) interface in AP to the internet through a data
cable
3 Configure the wireless network card for wireless users access