User Manual

RPC/RP Configuration RPC/RP Manual

WLL-RPC/RP-IN/UM-1.0 19June2000

Figure 4-55: Edit of Service Data 1 Window

Field Name Description

RP# RP ID number

Inst. Set “installed” or “not installed” for RPs according to

RP installation plan.

Phantom The power is supplied by the RPC.

Local The power is supplied by the RP power unit.

Save Save the setting to a local file.

Next Switch to the next Service Data window.

Cancel Cancel the editing.

Switch 1,2,3 Switch to one of the three Service Data windows.

Table 4-12: Edit of Service Data 1 Window Field Description

3. For each installed RP, enter a √ in the Inst. row. For each installed RP,

specify the power source by clicking on either the Phantom button or the

Local button. For WLL, the power source is Phantom. Local is for future

use when the power is 20 milliwatts or higher.

4.3.8.2 Service Data 2: Group Control Configuration

1. To get to the Edit of Service Data 2 window, click Next or Switch 2. The

Edit of Service Data 2 window opens, as shown in the figure below.