User Manual

RPC/RP Configuration RPC/RP Manual

WLL-RPC/RP-IN/UM-1.0 19June2000

Figure 4-67: EM Reset (RPC) Window

Field Name Description

Startup System Determine which SDM to use for operating RPC after resetting.

Prev. Previous ACT SDM. After resetting, RPC starts up and runs based on

the previous ACT SDM.

N System SDM-#N. After resetting, RPC starts up and runs based on SDM-#N.

E System SDM-#E. After resetting, RPC starts up and runs based on SDM-#E.

Table 4-16: EM Reset (RPC) Window Field Description

F NOTE: Refer to Section 4.3 for detailed description of the N and E systems.

5. There are three options in the Startup System block. Select the system to

start with and click OK.

6. A confirmation window appears, as displayed in the figure below. Click OK

to reset the RPC or Cancel to stop the transaction.

Figure 4-68: Reset Confirmation Window

7. After EM reset is complete, the PC will disconnect from the RPC. To resume

normal operations, reconnect to the RPC.

8. Click the RPC Status button to open the RPC Status View window to verify

that the component is in operation.