User Manual

RPC/RP Configuration RPC/RP Manual

WLL-RPC/RP-IN/UM-1.0 19June2000

FSU mobility limitation

This item is used for the control of FSU mobility limitation. Depending

on the setting value, one mode might be that RPC reports RP-ID to

WLL/V5WLL for mobility, the other mode might be that RPC doesn't

report RP-ID to WLL/V5WLL for mobility. In the case that RPC reports

RP-ID to WLL/V5WLL, WLL/V5WLL controls FSU mobility in

accordance with the subscriber setting. In the case that RPC doesn't report

RP-ID, FSU mobility isn't limited regardless of the subscriber setting. The

way of setting is as follows,

Bit 8 7 6 5 4 3 2 1

0 0 0 0 0 0 0 0 à The mode that RPC doesn’t report RP-ID

0 0 0 0 0 0 0 1 à The mode that RPC reports RP-ID

4.3.9 Change Data (RP Installation)

Use the procedure in this section to change the operation data for the selected

RPC. The diagrams displayed in this section are very similar to those in the

previous section. The only difference is that there are two configuration windows

instead of three.

1. To change the operation data for an RPC, click the Configuration main menu

and select the Service Data option, then the Change Data option, and then the

RP Installation option. This opens the RP Installation (Group

Composition 1) window, as displayed in the figure below.

F NOTE: Before making any changes to the operation data, be sure to block the

E1/IF and RP/IF. After the setting is modified, the RP/IF will restart itself.