User Manual

RPC/RP Configuration RPC/RP Manual

WLL-RPC/RP-IN/UM-1.0 19June2000

Finally, the frame at the bottom is the Self Messages window. It displays

messages about the command execution results, trap messages, or warnings, if

there is any.

4. To get connected to a certain RPC, reselect the RPC by clicking the RPC on

the Unit View window. A connection status box appears, displaying the

connection process. If the connection is successful, a message will appear on

the Connection View window, stating “Connected to RPC#…” If the

connection fails, the message will be: “Not Connected!”

5. When the connection is complete, the Status View window displays the

relevant status information about the RPC or other units under it, depending

on which unit is selected. The figure below illustrates an RPC window.

Figure 4-5: RPC Window

6. Open an RPC by clicking the + sign to the left of the RPC. This displays the

RPs, RP Interface Borad, E1 Signal, Node Interface Board, and Air Channel

inside. Users may access each of the RPs by clicking the + sign to the left of

the RPs. Each RPC controls 32 RPs.